TA09 - Tile/Shingle Anchor

The TA09 Tile/Shingle Fall Arrest Anchor is a concealed stainless steel ‘D’ ring anchor for application to the top of a rafter or top chord of a truss.  The anchor installs with a cordless drill in a few minutes.

TA09 Iso3The TA09 Fall Arrest Anchor requires no additional flashing kit and is manufactured from Stainless Steel. The anchor is bent to suit batten sizes and is drawn out between the two courses of tiles or shingles. The patented surface mounted design allows for easy fitting and the RD08 fall arrest anchor can be supplied powdercoated to colours matching corporate safety regimes or the substrate sheeting for an integrated application.

The TA09 Roof Anchor is limited to 180 degree use, that is, you must only work below it and on the same roof plane that it is fixed upon. The reason for this limitation is the shear load needing to be applied to all screws in the event of a fall. If you cross the ridge, there is potential that the screws are loaded in the event of a fall, one by one, and this will not resist the load required in AS1891.4 of 15kN.

Specifications:

  • For 180 DEGREES USE ONLY!
  • Patented design allows for easy retro fitting
  • Complies with AS 1891.4
  • Requires no flashing kit
  • 14 Ga. 304 Stainless Steel
  • Includes Instruction Manual/Tech Data Sheet
  • 15kN - Rated for single person Fall Arrest
  • FOR SINGLE PERSON USE ONLY!

Installation diagram:

TA09 


Technical Data Sheet:

Installer’s Certificate Download:

TA-09 Tile/Slate/Shingle Roof Anchor

Anchor Installation Certificate Download